"CHIP GARD" Is an optically clear 4-6 mil thick vinyl,  Two pieces (2) 14"x17"  @$35.00 USD

 Shipped from Canada to Canada $15.00 USD

 We Now Accept Paypal or Creditcards!

Remove all wax from the area the Chip Gard will be applied. Then clean the area a second time to make sure all wax or glaze is removed. With a Spray Bottle filled with water, spray each area where the film is to be applied, apply the film onto the wet surface and position to the desired location, then starting in the center of the film work outward left then right and up and down until all of the air and water is squeezed out from under the film. The "Chip Gard" is pretty tough so there is little chance you will harm it at this point, However if you have installed it crooked you simply remove it by lifting up a corner and reapply water and start over. Then gently continue to work into final position. 
If at anytime you are not happy, simply pull up and re-wet both fender and film with  water and start over. If almost dry and you find a big bubble you missed, it's best to just start over ... it's easy and fast enough to do. ... just normal gentle bike washing mitt or natural sponge and even being just a little bit careful around edges ...... one probably will only remove and re-apply film once or so a year, as it seals edges and no dirt will get between film and bike surface as long as you leave alone.
Of course, you'll apply and reapply a few times as you show friends how easy it is at first, but then all will settle down and the need to pull that edge up will fade.

 If you are viewing from the U.S.  and would like to place an order contact  www.VisualExpressions.us  . Thank you for visiting our site.

EXTRA INCHES

HOME